Police Digital Breath HX-64 LCD Display Breath Analyzer Alcohol Tester
Feature
1. Digital alcohol tester audible alarm
2. Measuring range: 0.00 - -0.19% BAC & 0.0 - -1.9 g / l (or 0.00 - -0.95 mg / l BRAC)
3. Fast response and recovery
4. Automatic shut-down
5. 2 X1.5V use alkaline batteries
Battery Installation
1. Open the battery compartment cover from the back of the tester prompted slide.
2. Press the icon requires two 1.5V alkaline batteries correctly
3. Close the battery cover.
Alcohol Tester use
Preheat
1. Press the power button to turn on the display alcohol tester, while the tester beep sound.
2. Alcohol Tester display "warm up", also shows the countdown from 10-0, the alcohol tester is in warm-up state.
Tips
When you first use alcohol tester, or not used for a long time, probably due to the alcohol sensor surface adsorption of large amounts of gas impurities on the tester performance. Thus the influence of alcohol tester is working properly. It must first clean up the alcohol sensor, and then press the power button as many times as possible preheat the tester.
test:
1. After preheating the end of the tester shows "Blow", also shows the countdown from 10-0. Tester into the test mode.
2. Close alignment of the blow hole blow 3--5 seconds.
3. Read test results from the alcohol tester display.
4. "Caution" is displayed on the right digital representation of the measured concentration of alcohol in the human body in the following range, indicating that people have tested drinking, driving to be careful:
0.02% BAC (or 0.2g / l) to 0.05% BAC (or 0.5g / l).
0.05% BAC (or 0.5g / l) to 0.08% BAC (or 0.8g / l)
5. "Danger" on the right digital display indicates the measured concentration of alcohol in the human body in the following range, while a beep sound alert. Description: test people drunk, driving dangerous.
over & equal 0.05% BAC (or 0.5g / l).
over & equal 0.08% BAC (or 0.8g / l)
Automatic shut-down
1. Test results are displayed after about 15 seconds later, LCD display shows "OFF" for about 2-3 seconds, automatically shut down alcohol tester
3. If the test has not aligned vent blowing alcohol tester, LCD display will show "0.00."
Note
In order to obtain a more accurate measurement results, the manufacturer recommends that you double-check 2-3 times.
Low battery indicator
If there is "L" symbol on the LCD display flashes, indicating that the battery is low, alcohol tester will automatically shut down, replace the battery.
Replace battery
When the alcohol tester can not automatically turn on or normal warm-up, please replace it with two AAA batteries.
Can be hung function
Please click icon require plastic key chain (packaging contents) in the Department of Alcohol Tester
Specification
* Sensor: advanced semiconductor oxide alcohol sensor
* Measuring range: 0.00% - -0.19% BAC (0.0--1.9 g / l or 0.00 - -0.95 mg / l BRAC)
* Accuracy: 0.01% BAC (0.1 g / l).
* Power: 2 X 1.5 v alkaline batteries
* Operating time: warm-up time: 10s, response time: <5 s
* Auto power off: about 35 seconds.
* Size: 95 x36x18mm
Forewarned
I recommend drinking alcohol for 20 minutes, then use alcohol tester checks. Because the body takes about 20 minutes to the digestive organs of absorption of alcohol into the bloodstream. In addition, the residual alcohol in the mouth also takes about 20 minutes to dissipate.
In order to make more accurate measurements, please do a second test within three minutes.
- Within 20 minutes before the test, please do not smoke or eat.
- Do not use chemicals such as benzene, thinner or gasoline direct testing alcohol tester.
- Do not blowing liquid alcohol tester airways
- Do not make any contact with irritating substances Alcohol Tester, such as: pain meter, pesticides, and other alcoholic beverages.
- Do not use alcohol tester placed in the air is polluted confined space.
- Modify or replace components inside the unit may cause malfunction of the tester
- This section is designed to help improve driving safety, can not be used as the use of vehicles, machinery, equipment, etc., and in accordance with the operation. Blood alcohol intoxication and measures referred to in this design does not reference from non-governmental, medical institutions, agencies or individuals offer. BAC solely as a reference, the manufacturer does not assume any liability.
- Each person's sensitivity to alcohol, some people may want to test instrument based on the body below the legal alcohol content standards.
| Material |
ABS |
| Detection range |
0.00% - 0.19% BAC / 0.00- 0.95 mg/l |
| Sensor |
Semiconductor alcohol sensor |
| Digital display results |
% BAC / mg/l |
| Warm-up time |
Within 10 seconds |
| Respond time |
Within 5 seconds |
| temperature range |
5 ~ 40 oC |
| Power input |
2*AAA 1.5V alkaline batteries (not included) |
Audited Supplier 
Audited Supplier 
){kind=link}
){kind=link}